![]() ![]() ![]() Restarting the remote device failed more than 5% of the tests. Workaround: Refer to the Test-IPMI.log file to get detailed error information. Retrieving the BMC log entries failed more than 5% of the tests. Retrieving BMC information failed more than 5% of the tests. Error 1: Initialization failedĪn error occurred while preparing to run the test. The following diagram shows how to configure your hardware for IPMI reliability testing.įor generic troubleshooting of HLK test failures, see Troubleshooting Windows HLK Test Failures. Note that the SUT server must have its BMC interface connected to the network. You must connect all computers to the same physical network.You must configure the server's baseboard management controller (BMC) with IP address settings, and enable the BMC to allow remote management using IPMI. Refer to Windows HLK prerequisites for more details. A server running the HLK controller and a test computer to act as the HLK proxy.The following hardware is required to test IPMI functionality. Tests in this feature area might have additional documentation, including prerequisites, setup, and troubleshooting information, that can be found in the following topic(s): This automated test validates various features of a baseboard management controller (BMC) with the Intelligent Platform Management Interface (IPMI) protocol. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |